This article is shows how to make a SD card smaller than 8G bootable under Windows, using Cardtricks. To make any size SD card bootable under Windows, follow the instructions at SDM Quick Start using stminste.exe downloaded from SDM Downloads and Updates. To make a card bootable on a Mac - use the SDMInst app as described here FAQ/Mac

NOTE: Video needs to be updated...Follow instructions for now

Total Beginner Edit

1. You can follow along using this video http://www.youtube.com/watch?v=n7dVeImIWz0
2. Take an SD memory card and insert it into a card reader (a USB Card Reader, Internal Card Reader, etc). You can buy one from RadioShack, Bestbuy, Amazon, any electronics store
3. Connect the card reader to the computer
4. When the message shows up asking what you want to do with the files on the card, ignore it, and click on the X to close it
5. Download and install CardTricks
6. After CardTricks starts, click on the stamp icon of the SD card. Pick the SD card's drive letter (usually the last one)
7. You will see the details for the SD card
8. Click Format As FAT, click through the warnings (make sure that the card does not have anything you need). This will take up 10 minutes. You can check the progress in a command prompt window to the right of the CardTricks window on the taskbar
9. After the format is finished, click Make Bootable, and click OK
10. Download a build of CHDK for your camera - most likely it will be the latest one (if you purchased your camera recently). However, in a lot of cases it is not. But either way, you will find out soon.
11. Click CHDK->Card in CardTricks. Select the build you just downloaded
12. Click OK, and the build should now be on your card
13. VERY IMPORTANT STEP!!!!: Take the card out of the card reader, and slide the lock to the "ON" position. Insert the card into your camera....
14. Turn the camer a on. You should see a screen like this:
15. If you don't, either you made a mistake following the directions OR you have the wrong firmware version number. To find out:
    1. Turn your camera to PLAY mode
    2. Hold down The SET key
    3. Keeping SET down, press Display
    4. You should see something that says Firmware Ver GMx.xxy (example GM1.01B)
    5. Remember what x.xxy are. This is your firmware version.
    6. Repeat the procedure above, downloading the correct firmware
    7. If you do not see any of this, most likely you installed the wrong version of CHDK. Try checking the lock slider, and that you pressed the CHDK->Card Button!

Email me at adz@jewc.org for questions.